Bidets are an indispensable part of any bathroom. But, have you ever considered, how much time you waste in using the same old faucet for bidet, and just to stop the stream of water going down your back? To help you gain some insight into this area, the author has put together a list of different versions of bidets and decided to write an article on how to change your bidet faucet.
How To Change Bidet Faucet; A simple step below.
Step 1: Remove the old faucet:
The first step is to remove the old faucet. Use pliers or wrenches, and unscrew it from its place on the back of your bidet unit. It cannot be taken off without this tool. If you have installed new cartridges in your bidets recently, then this step can also be a bit tricky. Because of the cartridges, it is not easy to remove them without damaging your bidet unit. This may cause you some trouble in changing the faucet later on.
Step 2: Remove old cartridge:
Once you have removed its base from the back of your bidet, you can take it out by unscrewing its cartridge. This is a very important step to remove the old cartridges because they are used to change the settings on your new faucets.
Step 3: Install new cartridges:
Like I said earlier, this step may be tricky when you have just installed the new cartridges recently. You will need to do some trial and error before you can figure this out, but it mostly depends on how many tags are left in your cartridge slots. If there is only one tag, then simply pop out two or three of them and then push in three new cartridges. Before you press the cartridge into its slot, it will click on itself with a sound that is similar to when we use coins for change at counters.
Step 4: Turn off the water supply:
Now that you have the new cartridges installed, it is time to turn off the water supply. You can do this by pulling out a lever on your tank or faucet for hot and cold openings respectively. Turn off both of them at once when you are done with changing your parts!
Step 5: Unscrew the old faucet:
Now that the water supply is off, you can remove the old faucet. This part gets a bit tricky and it’s best to ask for some help from someone who knows how to do this job properly if possible.
Step 6: Remove the old washer:
Now that you have removed the old faucet, it’s time to take out its washer. This part is located on the back of your bidet and it may be a bit tricky for someone who has just installed new cartridges before.
Step 7: Screw in the new washer:
Once you have removed the old washer, it’s time to install a new one. Simply screw it in like how you screwed out the previous washer!
Step 8: Screw on new cartridges
Step 9: Turn on the water supply:
If you are done with all the previous steps, then it is time to turn on your water supply.
Step 10: Test bidet function:
Before turning off the cold water and hot opening valves again, check if your bidets still work properly! If they do not have any issues after being repaired, simply turn off the valves that you have just connected back on.
Conclusion
Now your bidet is fixed and ready to go! You can now use it as usual or clean out all of the sludge from its nozzle in between uses like we did during this tutorial!
You can also use a new one if you have to replace your bidet faucet. Bidet faucets can be a handy addition to your bathroom. But you might want to replace yours if it’s not functioning properly. Bidet faucets are quite affordable, so you will not have to spend a lot of money on them. You can pick up Bidet Converter Kit for around $40-$70 and they should work just fine!
